Preparation stage:
Clean the installation position, remove dust and other dirt to improve the adhesion effect.
Apply adhesive aid or 952 adhesive (a common automotive sealing strip adhesive) to the back of the installation position.
Installation phase:
Peel off one end of the sealing strip from the backing adhesive, so that it can tightly fit into the installation position.
Press and tear off excess adhesive while ensuring that the sealing strip is tightly attached and free of bubbles.
For corners or other parts that are difficult to fit directly, one side of the adhesive strip can be cut open to form an opening for flexible rotation direction.
Be careful not to directly attach the sealing strip to the drainage outlet to avoid blockage; When encountering a drainage outlet, a position should be left after the rubber strip is cut.
Completion stage:
Check if the sealing strip is securely installed in the required position, especially if there are any missing edges or corners.
If the environment is humid or the temperature is below 10 ° C, it may be necessary to use a hot air fan to heat the adhesive strip to enhance its adhesion.
Regularly check the condition of the sealing strip, and if hardening occurs, it should be replaced in a timely manner.
The above steps combine information from multiple sources, but please note that the specific installation method may vary depending on the vehicle model and personal experience. In practical operation, it is recommended to consult the specific guidance provided by the vehicle manufacturer or contact a professional repair shop for more accurate assistance.
